I found … this link. There are two screws underneath there. Carefully pull bulb straight out of the socket and push in the new bulb. There are clear, detailed photos and step-by-step instructions. Connect the electrical connector into the rear of the plastic base unti it snaps, locking it into position.
Later on that day my wife emailed me the part listing on Go-Parts. Two months later, long after it was installed, my wife let me in on a little secret. Facing the driver's side headlamp, and looking at the headlamp itself, at clock positions 8, 11 and 1 are the headlight housing s … crews. This is the second time this has happened. Take new bulb and notice the notches.
Remove the bulb retaining ring by rotating it counterclockwise when viewed from the rear to free it from the bulb socket, and slide the ring off the plastic base. Under the hood there is a locking ring of sorts holding the lamp in place. Follow these instructions Remove 3 top Bezels screws. Now undo the 3 screws holding the mirror on, unconnect power cable if you have power mirrors. At this point you can replace the headlight bulb, turn signal bulb, or the entire headlight assembly.
Nov 22, 2012 1 Remove the front grill. The Owners Manual has the steps and illustrations around page 37. . After that, just pull the bulb out and replace. Screw on the back of the assembly. First get a small screw driver or blade.
Holding the new bulb by the base, you will see 3 small detents two of them rather close together, and the other on the opposite side of the base. With the cable unplugged, look at the back of the bulb assembly. Pull it straight back away from you to remove it. Look down on the assembly and toward the side closest the radiator you will see a small bolt to unscrew on each housing. Holding the new bulb by the base, you will see 3 small detents two of them rather close together, and the other on the opposite side of the base.
Remove the bulb from the lamp assembly by pulling straight back. Item in Good Condition Guaranteed If the part we ship to you arrives in damaged or non-working condition, we will ship another item out to you immediately. Do not twist, as there are alignment slots built into the lamp assembly socket. So I tell my wife and she starts surfing the Internet trying to find the best deal. Do not touch the glass of the new halogen bulb - the oils in the skin will shorten the life-span of the new bulb, or possibly cause the bulb to explode when first turned on If the bulb is accidentally touched, it should be cleaned with rubbing alcohol before being used. By the hinge of the door at the bottom by the speaker there is a black plastic button screw pull this out. The headlamp assembly will now pull forward providing great access to the electrical connector and bulb retainer ring.
Screws at 11, 1 and 4 o'clock positions. By the hinge of the door at the bottom by the speaker there is a black plastic button screw pull this out. Do not twist, as there are alignment slots built into the lamp assembly socket. Chances are these steps also apply to the Freestar and Mercury Monterey. Check out this site: www. Place headlamp back into position. To remove it all you do is remove the hinge bolts.
Keep the ring to retain the new bulb. It may take some effort to remove the lamp because it has a rubber o-ring type seal - try a bit of wiggling side-to-side while pulling. This information is illustrated and detailed in the Owners Manual. Set the turn signal assembly aside. This procedure is well detailed, with illustrations, in the Owners Manual. Screws at 11, 1 and 4 o'clock positions.